Which Nevada contractor license does your yard or concrete job need?

Most yard and concrete projects in Nevada need a contractor licensed by the Nevada State Contractors Board (NSCB). Landscaping is C-10, poured concrete is C-5, and pavers, stone and block are C-18. Mowing, cleanup and trimming need no contractor's license. This guide shows where each line falls.

Get matched Takes about a minute.

Quick table: job to license

JobLicense
Mowing, edging, cleanup, haul-off, trimming, thatchingNone (NSCB)
Weed or insect sprayingNDA pest-control license in many cases
Planting, sod, hydroseed, xeriscape rockC-10
Sprinkler or drip install and repairC-10 or C-1d
Backflow device at the water tie-inC-1d (C-10 coverage unconfirmed)
Landscape drainageC-10
Mass gradingA-7 or A-12
Landscape lighting up to 24 V with landscape workC-10
New outlet or line-voltage lightingC-2
Brick or stone walk up to 200 sq ft / patio up to 400 sq ft, with landscape workC-10 or C-18
Paver patio or walk, any sizeC-18
Paver drivewayC-18, never C-10
Landscape retaining wall up to 3 ftC-10 (with landscape work), C-18 or C-5
Wall over 3 ftC-18 or C-5, engineering as required
Any poured concrete: driveway, patio, walk, steps, padC-5
Gas line to a fire pit or kitchenC-1d
Asphalt paving or sealcoatA-16 or A-8
FenceC-25
Engineered fountain or waterfallA-24
Attached pergola or patio coverB-2 (or carpentry)

The three core licenses, in the regulation's words

C-10 landscape (NAC 624.280): may "grade and prepare plots of land for architectural horticulture," plant and maintain "gardens, lawns, shrubs, vines, bushes, trees," "construct systems of drainage and landscape irrigation," install rock and gravel "that use xeriscape principles," hydroseed, control erosion, and install nonengineered ponds, trellises and arbors.

C-5 concrete (NAC 624.230): may place reinforcing steel, "pour, place, finish and install concrete," build forms, apply sealants and waterproofing, and "saw, cut, drill and core concrete and asphaltic paving material."

C-18 masonry (NAC 624.350): may "select, cut and lay brick, other baked clay products, rough cut and dressed stone, artificial stone, precast blocks and structural glass brick or block … with or without mortar." No size limit.

None of the three has subclasses today. Former C-10a, b and c and C-5a and b were folded in years ago, though some older C-5 licenses carry a cutting-only restriction.

The C-10 hardscape limits

"In conjunction with" landscape work, a C-10 may install nonload-bearing brick or stone walkways up to 200 sq ft, brick or stone patios up to 400 sq ft, landscape retaining walls up to 3 ft, and landscape lighting up to 24 volts (NAC 624.280). Those numbers limit C-10. They don't mark where C-18 starts; C-18 covers any size.

Whether concrete pavers count as "brick or stone" isn't settled by NSCB, so we treat most paver jobs as C-18 work.

What needs no license

NSCB's consumer guide says licensed contractors are not needed for "mowing/edging of lawns; cleaning up/hauling off debris; removal and trimming of trees and shrubs; or thatching of lawns" (NSCB).

The repair exemption and the $500 rule

NRS 624.031(6) exempts repair or maintenance work under $1,000, unless a building permit is required, the work is of a type done by plumbing or electrical contractors, it significantly affects public health and safety, it's part of a larger project worth $500 or more, or it's done by a licensee (NRS 624.031). Most yard projects fail at least one of those tests.

Irrigation is also plumbing

Landscape irrigation is listed in both C-10 and C-1d plumbing scopes. Because the small-repair exemption doesn't apply to plumbing-type work, we route all sprinkler work, even small repairs, to licensed contractors.

Pesticides need a separate license

The Nevada Department of Agriculture requires a license for many weed and insect spraying jobs, including advertising pest control or bidding maintenance contracts that involve pesticide applications (NDA).

"Landscape designer" is a protected title

NRS 623A makes it a misdemeanor to use titles such as landscape architect, landscape designer or landscape consultant without registration (NRS 623A). Licensed contractors may prepare drawings for their own construction work.

How to verify a license

  1. Get the license number from the contractor or their bid. Bids and contracts must show it, plus the monetary limit (NAC 624.640).
  2. Search it on the NSCB License Search.
  3. Check status, classes, limitations and monetary limit.

Each class is a separate application under NAC 624.590, which is why some firms hold several license numbers.

Frequently asked questions

Does a lawn service need a license in Nevada?

Not for mowing, edging, cleanup, trimming or thatching, according to NSCB. Spraying can need an NDA license.

Can a landscaper pour concrete?

No. Poured concrete is C-5 work.

Is there a $1,000 exemption?

For some repair and maintenance work, with several exceptions, including any project worth $500 or more.

Ready to get matched?

Pick what you need and leave your contact info. An independent local pro gets in touch.

Related pages

Get matched